|Listed in category:
Have one to sell?

Marauder SERIES #1 1:12 Scale Weapons for 6" GI Joe Classified -Factory Produced

Condition:
New
7 available / 5 sold
Price:
US $12.99
ApproximatelyPHP 749.48
Postage:
US $3.95 (approx PHP 227.90) Standard Postage. See detailsfor shipping
Located in: Pittsfield, Massachusetts, United States
Delivery:
Estimated between Fri, 3 May and Mon, 6 May to 43230
Delivery time is estimated using our proprietary method which is based on the buyer's proximity to the item location, the postage service selected, the seller's postage history, and other factors. Delivery times may vary, especially during peak periods.
Coverage:
Read item description or contact seller for details. See all detailsSee all details on coverage
(Not eligible for eBay purchase protection programmes)

Seller information

Seller assumes all responsibility for this listing.
eBay item number:204735440379
Last updated on Apr 23, 2024 00:05:35 PHTView all revisionsView all revisions

Item specifics

Condition
New: A brand-new, unused, unopened, undamaged item. See the seller's listing for full details. See all condition definitionsopens in a new window or tab
Brand
MARAUDER
Type
Action Figure
Scale
1:12
Material
ABS Plastic
Franchise
GI JOE

Item description from the seller

marauder-gun-runners

marauder-gun-runners

100% positive feedback
146K items sold
Usually responds within 24 hours

Detailed Seller Ratings

Average for the last 12 months

Accurate description
5.0
Reasonable shipping cost
5.0
Shipping speed
5.0
Communication
5.0

Seller feedback (49,237)

j***b (1889)- Feedback left by buyer.
Past month
Verified purchase
Item as described! I honestly couldn't tell if the chest detail was a sticker or a waterslide. It's a thin sticker, thankfully cut out... ...It doesn't stay on too well though... Would work fine on a "paved over" surface instead of a rippled shirt. Will have to figure out a way to make it stay on more flush...
j***b (1889)- Feedback left by buyer.
Past month
Verified purchase
Item as described! I honestly couldn't tell if the chest detail was a sticker or a waterslide. It's a thin sticker, thankfully cut out... ...It doesn't stay on too well though... Would work fine on a "paved over" surface instead of a rippled shirt. Will have to figure out a way to make it stay on more flush...
Reply from: marauder-gun-runners- Feedback replied by seller marauder-gun-runners.- Feedback replied by seller marauder-gun-runners.
Hi! Put the sticker in the desired location and then use a blowdryer to heat it up and contour it into place. Also, another method is to put a little super glue gel under the sticker and press it out towards the edges. No worries! MJ
s***p (218)- Feedback left by buyer.
Past month
Verified purchase
Tremenda figura marauder best of the best thanks